Documentation: Remove references to dead "noasync" kernel parm

[cascardo/linux.git] / Documentation / kernel-parameters.txt

diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt
index 63bda36..59b1ab5 100644 (file)
--- a/Documentation/kernel-parameters.txt
+++ b/Documentation/kernel-parameters.txt
@@ -222,9 +222,6 @@ and is between 256 and 4096 characters. It is defined in the file
                        Warning: Many of these options can produce a lot of
                        output and make your system unusable. Be very careful.
 
-
-       acpi_fake_ecdt  [HW,ACPI] Workaround failure due to BIOS lacking ECDT
-
        acpi_pm_good    [X86-32,X86-64]
                        Override the pmtimer bug detection: force the kernel
                        to assume that this machine's pmtimer latches its value
@@ -479,6 +476,16 @@ and is between 256 and 4096 characters. It is defined in the file
                        UART at the specified I/O port or MMIO address.
                        The options are the same as for ttyS, above.
 
+       no_console_suspend
+                       [HW] Never suspend the console
+                       Disable suspending of consoles during suspend and
+                       hibernate operations.  Once disabled, debugging
+                       messages can reach various consoles while the rest
+                       of the system is being put to sleep (ie, while
+                       debugging driver suspend/resume hooks).  This may
+                       not work reliably with all consoles, but is known
+                       to work with serial and VGA consoles.
+
        cpcihp_generic= [HW,PCI] Generic port I/O CompactPCI driver
                        Format:
                        <first_slot>,<last_slot>,<port>,<enum_bit>[,<debug>]
@@ -487,6 +494,13 @@ and is between 256 and 4096 characters. It is defined in the file
                        [KNL] Reserve a chunk of physical memory to
                        hold a kernel to switch to with kexec on panic.
 
+       crashkernel=range1:size1[,range2:size2,...][@offset]
+                       [KNL] Same as above, but depends on the memory
+                       in the running system. The syntax of range is
+                       start-[end] where start and end are both
+                       a memory unit (amount[KMG]). See also
+                       Documentation/kdump/kdump.txt for a example.
+
        cs4232=         [HW,OSS]
                        Format: <io>,<irq>,<dma>,<dma2>,<mpuio>,<mpuirq>
 
@@ -597,9 +611,6 @@ and is between 256 and 4096 characters. It is defined in the file
                        Format: {"of[f]" | "sk[ipmbr]"}
                        See comment in arch/i386/boot/edd.S
 
-       eicon=          [HW,ISDN]
-                       Format: <id>,<membase>,<irq>
-
        eisa_irq_edge=  [PARISC,HW]
                        See header of drivers/parisc/eisa.c.
 
@@ -875,9 +886,6 @@ and is between 256 and 4096 characters. It is defined in the file
        lapic_timer_c2_ok       [X86-32,x86-64,APIC] trust the local apic timer in
                        C2 power state.
 
-       lasi=           [HW,SCSI] PARISC LASI driver for the 53c700 chip
-                       Format: addr:<io>,irq:<irq>
-
        libata.noacpi   [LIBATA] Disables use of ACPI in libata suspend/resume
                        when set.
                        Format: <int>
@@ -994,6 +1002,8 @@ and is between 256 and 4096 characters. It is defined in the file
 
        mce             [X86-32] Machine Check Exception
 
+       mce=option      [X86-64] See Documentation/x86_64/boot-options.txt
+
        md=             [HW] RAID subsystems devices and level
                        See Documentation/md.txt.
 
@@ -1123,9 +1133,6 @@ and is between 256 and 4096 characters. It is defined in the file
        noapic          [SMP,APIC] Tells the kernel to not make use of any
                        IOAPICs that may be present in the system.
 
-       noasync         [HW,M68K] Disables async and sync negotiation for
-                       all devices.
-
        nobats          [PPC] Do not use BATs for mapping kernel lowmem
                        on "Classic" PPC cores.
 
@@ -1563,9 +1570,6 @@ and is between 256 and 4096 characters. It is defined in the file
        sa1100ir        [NET]
                        See drivers/net/irda/sa1100_ir.c.
 
-       sb=             [HW,OSS]
-                       Format: <io>,<irq>,<dma>,<dma2>
-
        sbni=           [NET] Granch SBNI12 leased line adapter
 
        sc1200wdt=      [HW,WDT] SC1200 WDT (watchdog) driver
@@ -1609,8 +1613,6 @@ and is between 256 and 4096 characters. It is defined in the file
 
        serialnumber    [BUGS=X86-32]
 
-       sg_def_reserved_size=   [SCSI]
-
        shapers=        [NET]
                        Maximal number of shapers.