memory {
device_type = "memory";
- reg = <0x80000000 0x40000000>; /* 1024 MB */
+ reg = <0x0 0x80000000 0x0 0x40000000>; /* 1024 MB */
};
aliases {
};
};
- sound0: sound@0 {
+ sound0: sound0 {
compatible = "simple-audio-card";
simple-audio-card,name = "DRA7xx-EVM";
simple-audio-card,widgets =
};
pcf_gpio_21: gpio@21 {
- compatible = "ti,pcf8575";
+ compatible = "nxp,pcf8575";
reg = <0x21>;
lines-initial-states = <0x1408>;
gpio-controller;
status = "okay";
pinctrl-names = "default";
pinctrl-0 = <&nand_default>;
- ranges = <0 0 0 0x01000000>; /* minimum GPMC partition = 16MB */
+ ranges = <0 0 0x08000000 0x01000000>; /* minimum GPMC partition = 16MB */
nand@0,0 {
/* To use NAND, DIP switch SW5 must be set like so:
* SW5.1 (NAND_SELn) = ON (LOW)
* SW5.9 (GPMC_WPN) = OFF (HIGH)
*/
+ compatible = "ti,omap2-nand";
reg = <0 0 4>; /* device IO registers */
+ interrupt-parent = <&gpmc>;
+ interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
+ <1 IRQ_TYPE_NONE>; /* termcount */
+ rb-gpios = <&gpmc 0 GPIO_ACTIVE_HIGH>; /* gpmc_wait0 pin */
ti,nand-ecc-opt = "bch8";
ti,elm-id = <&elm>;
nand-bus-width = <16>;
gpmc,bus-turnaround-ns = <0>;
gpmc,cycle2cycle-delay-ns = <0>;
gpmc,clk-activation-ns = <0>;
- gpmc,wait-monitoring-ns = <0>;
gpmc,wr-data-mux-bus-ns = <0>;
/* MTD partition table */
/* All SPL-* partitions are sized to minimal length
serial-dir = < /* 0: INACTIVE, 1: TX, 2: RX */
1 2 0 0
>;
+ tx-num-evt = <32>;
+ rx-num-evt = <32>;
};
&mailbox5 {