[media] vb2: use pr_info instead of pr_debug

Modern kernels enable dynamic printk support, which is fine, except when it is
combined with a debug module option. Enabling debug in videobuf2-core now produces
no debugging unless it is also enabled through the dynamic printk support in debugfs.

Either use a debug module option + pr_info, or use pr_debug without a debug module
option. In this case the fact that you can set various debug levels is very useful,
so I believe that for videobuf2-core.c we should use pr_info.

The mix of the two is very confusing: I've spent too much time already trying to
figure out why I am not seeing any debug output in the kernel log when I do:

	echo 1 >/sys/modules/videobuf2_core/parameters/debug

Signed-off-by: Hans Verkuil <hans.verkuil@cisco.com>
Signed-off-by: Mauro Carvalho Chehab <m.chehab@samsung.com>

diff --git a/drivers/media/v4l2-core/videobuf2-core.c b/drivers/media/v4l2-core/videobuf2-core.c
index eb86913..5b808e2 100644 (file)
--- a/drivers/media/v4l2-core/videobuf2-core.c
+++ b/drivers/media/v4l2-core/videobuf2-core.c
@@ -36,7 +36,7 @@ module_param(debug, int, 0644);
 #define dprintk(level, fmt, arg...)                                          \
        do {                                                                  \
                if (debug >= level)                                           \
-                       pr_debug("vb2: %s: " fmt, __func__, ## arg); \
+                       pr_info("vb2: %s: " fmt, __func__, ## arg); \
        } while (0)
 
 #ifdef CONFIG_VIDEO_ADV_DEBUG